Chiller compressor exhaust temperature is too high, what are the major hazards?
2017-05-02 14:17:52http://www.szdxj.com admin
As we all know, the exhaust temperature is an important parameter in the operation of the refrigeration compressor. If the temperature of the exhaust valve is too high, it will cause the overheating of the compressor. Next, the East Star about the operation of the exhaust temperature is too high on the impact of industrial chillers.
1, once the compressor exhaust temperature is too high, will directly lead to lubricating oil and refrigerant in the metal catalytic thermal decomposition, and will produce harmful to the compressor acid, free carbon, moisture. Free carbon will sink on the exhaust valve, not only to undermine its seal, but also increase the flow resistance, the carbon slag is stripped out of the compressor, will block the capillary and dryer. Acids can corrode the components and electrical insulation of the chiller system. Water will be blocked capillary.
2, the compressor exhaust temperature is too high will directly reduce the gas transmission coefficient, shaft power increases. But the oil viscosity lowers bearings and the cylinder piston ring, abnormal wear, even cause the burning bush and cylinder galling accident.
3, cold water machine operator should check the overheating of the compressor, if the overheating is serious, will lead to excessive expansion of the piston and stuck in the cylinder, will also cause the built-in compressor motor burned.
4, the compressor exhaust temperature is too high will directly affect its service life, because the chemical reaction rate is increased with the increase of temperature. In general, the temperature of electrical insulating material rises 10 degrees centigrade, then its life is reduced by half. This is particularly important for fully enclosed compressors.
In short, the East Star on the operation of the exhaust temperature is too high on the impact of industrial chillers have the above content, we have a profound analysis and summary. We must limit the exhaust temperature of the compressor, so as to better promote the development of the industry.
For more information please contact us: Mr. Wang 13923464030 Tel: 0755-81715045 or visit our website: http://www.szdxj.com