An open chiller for injection molding
2017-05-18 09:23:39http://www.szdxj.com admin
Fierce competition in the industry, Shenzhen cold water equipment industry in the same industry is doing more prominent. Today I will introduce an open chiller.
An open chiller for plastics
Injection molding, blow molding, bottle blowing, pressure molding, blown film, calendering film
Standard industrial chillers can be applied to these industries.
A, injection mold cooling
After the melted plastic into a mold, condensation, mold ejection molding plastic workpiece, in the continuous production process with the need for cooling of the mold, so as to shorten the setting time of plastic, improve the dimensional accuracy, surface quality and molding quality.
Frozen water stability requirements: 6-18 degrees
Freezing water temperature difference requirement: + 2K or + 0.5K
Chiller cooling capacity and injection molding machine injection volume (usually referred to as "Ann") related to, the greater the injection molding capacity, the required cooling capacity is also large.
Usually in the injection molding machine clamping force nominal, which needs to be converted into tons of Oz, but is not a one-to-one correspondence with tons of Oz, table below is only the general condition of the transformation, and there is a certain upper and lower deviation.
For more information, please contact us: Mr. Wang, 13923464030, Tel: 0755-81715045 or login at our website: http://www.szdxj.com
.